Description
AIRBRUSH HOLDER
This support can hold up to 4 airbrushes : 2 with the black supports at the bottom and 2 with the yellow support at the top.
You can install it in different ways:
- At the edge of your work table with a screw system for firm fixing ( maximum thickness of the table: 5.5 cm)
- On the manometer of your compressor (see photo 3).
- Placed directly on the table (by removing the fixing system with the screw). The underside is non-slip in order to remain stable.
You can install it in different ways:
- At the edge of your work table with a screw system for firm fixing ( maximum thickness of the table: 5.5 cm)
- On the manometer of your compressor (see photo 3).
- Placed directly on the table (by removing the fixing system with the screw). The underside is non-slip in order to remain stable.
Each airbrush holder is swivel. The inclination of the yellow support can also be adjusted using the screw on the side.
Dimensions:
- Height (without clamp): 12.5 cm
- Maximum height (with the clamp fully open): 29 cm
- Maximum height (with the clamp fully open): 29 cm
- Maximum width: 8.5 cm
Sold alone (without airbrush or compressor)
Made in China
Made in China
Spec Sheet or Guide/Tutorial
Before using the product, we advise you to read the safety data sheet, the instructions for use, the blog article (guide or tutorial) or the technical sheet.
DECO CUIR, the leather work specialist
Since 2009, we have been supporting individuals and professionals.
-
1st French site for leather work
-
Physical store in Campbon (44)
-
Quality leather from tanneries / tannery or destocking of major leather goods brands