The necessary equipment:
- 1 SATINATO cowhide leather skin - from 0.70 to 0.79 m²
- 1 strip of vegetable tanned collar leather - Thickness 2.5 mm - Width 25 mm - Length 120 cm
- 8 medium DOUBLE CAP brass rivets (T3)
- A cutter
- Polyester thread no. 30
- A round cookie cutter with a diameter of 3 mm
1. Report the pattern
Download the pattern and print it in actual size. Cut out the paper pattern and transfer it onto the leather using a silver pencil.
2. Prepare the parts
Cut out the pattern pieces using a craft knife or scissors. Mark the center points of the pieces (indicated on the pattern) with a notch.
 |
 |
3. Glue the pocket
Using double-sided tape, glue piece P3 (pocket) onto P1, in the location provided on the pattern.
 |
 |
4. Drill the holes
Drill the holes on part P1. For oblong holes, make two holes with the Ø 3 mm round punch, then connect the two holes with a cutter.
 |
 |
5. Place the double-sided tape
Place double-sided tape on the lengths of piece P1 (on the wrong side).
6. Sew the pocket
Sew pocket P3 to P1.
7. Assemble the parts
Glue pieces P2 to P1 with double-sided tape, edge to edge, wrong sides together. Start from the middle to ensure a tight fit. Hold everything in place with sewing clips.
 |
 |
8. Sew the pieces
Sew pieces P1 and P2 edge to edge.
 |
 |
9. Prepare the strips
Cut the collar strap in half to make two handles.
10. Place the rivets
Fix the handles in the oblong holes with rivets.
 |
 |
You're done!
 |
 |
 |
 |
